1 All dimensions are measured by hand, there may be small deviations. 2 Color may vary slightly due to the color setting of each individual monitor. 3 The camera's power voltage is only for 12 voltage, so it can not support the car of 24 voltage.1 According to the original factory specifications. 2 High-definition and 170 degree wide viewing angle. 3 Shockproof, IP67, anti-interference and resistance to high/low temperature. 4 Super low-light, high quality image capabilities, high resolution, high sensitivity and high signal to noise ratio. 5 With cable(6 meters long), is enough to provide a stable performance and completely undisturbed by radio wave.
6 DSP digital chip, image clarity without distortion. 7 Embedded mounting in rear bumper. 8 This camera can give you a full sight of the back of your car when you are driving. 9 To protect your car from collision with invisible obstacle, choose a high definition and good quality camera as ours.
Everything you need to install a rear camera on the back of your vehicle(the number plate light), and then connect the cable with your car monitor and start to use. 1 Install the camera in the plate number light of your car. 2 Adjust the lens of camera to its best view. 3 Connect the video output(the yellow cable) of the camera to the display in your vehicle. 4 Connect the power cord to your vehicle DC 12V power system.This item is in the category "Vehicle Parts & Accessories\Car Parts & Accessories\Advanced Driver Assistance Systems\Parking Assistance\Parking Cameras". The seller is "liqer2" and is located in this country: CN. This item can be shipped worldwide.