Wireless Reversing Camera, Monitor Kit 4.3 Front Rear View Camera Backup

4.3 inch TFT monitor provides clear, clean image, display ratio: 16:9, pixel resolution: 628x582, CCD chipset that is compatible with both PAL and NTSC video systems. Easy installtion:connect the monitor with cigrette lighter, connect the camera with backup light, proving easy and convenient operation. Backup rear view camera with true color reproduction and video output of 1.0V PP-75 Ohm.

It has a low lux performance and a wide viewing angle at 170°. Has color image reproduction and auto white balance. IP68 waterproof, shockproof, high temperature resistance, high humidity resistance. Built-in smart chipset automatically powers up screen when needed. Highly prevent accidents to save you from unnecessary loss or troubles while driving in reverse by avoiding children, traffic, pedestrians, toys, and pets.

High-definition Images: This car camera system monitor comes with a slim 4.3 LCD full color display. Besides, the camera has a high quality CMOS sensor, providing clear, clean video. The wire connection of this wireless backup camera and monitor kit is very simple. There is no need to run extra RCA cable through the vehicle, because the transmission of video signal is wireless. All you need to do is powering the camera and the monitor.

Before mounting the camera, please connect the wireless transmitter to your reverse light power. Insert the monitor's cigarette lighter plug into car cigarette lighter interface to power the monitor. Then check if the camera and monitor kit works properly. If it works normally, then you can install the backup camera. If it can not work normally, please check whether the wire is correctly connected. How to power the camera. Connect the power to the camera and you can do that by simply connecting it to the red wire and the 12 volts power. Black cable should go to the ground as usual.

The Power that goes to the camera often comes from the reverse tail light. Fuse the transmitter wires with the reverse light wires.

Make sure you poke your positive (usually red) bare wire through the positive reverse light wire and the negative (usually black) bare wire through the negative reverse light wire. For safety, make sure you wrap the combined wires in electrical tape. Instantly Sends Camera Video to LCD Display Simple Installation. LCD size/type: 4.3' TFT LCD Screen Power Supply: 12V. IP-68 Waterproof Resolution:628x582 Rotatable Angle: 170 Degree Frame rate: 30fps Power Supply:12V. 1 x 4.3 LCD Monitor With One Cigarette Lighter 1 x Rear View Camera 1 x Installation Manual.